Intel TS-ASP3 ユーザーズマニュアル

This motherboard supports two 40-pin IDE connectors marked as IDE1 (primary channel) and

IDE2 (secondary channel).  Each channel supports two IDE devices for a total of four devices.

Connect your Hard Disk Drive (the main hard disk drive (HDD)  if you are using more than one)

to the “Master” connector (at the end of the cable) and connect it to IDE1 (see important note

below).  If your HDD supports Ultra DMA/66, you must use an 80-wire cable, otherwise the HDD

won’t be able to reach this speed.

If you intend to operate two IDE devices from the same channel, one device must be set to

“Master” mode, the other to “Slave” mode.  A Hard Disk Drive, CD ROM or other IDE device can

have either setting depending on the device’s jumper.  Please refer to the device’s manual for

more information.

P I N 1

P I N 1

S e c o n d a r y   I D E   C o n n e c t o r

Primary IDE Connector

I D E 2

I D E 1