HP (Hewlett-Packard) 6631B ユーザーズマニュアル

1 – Quick Reference

Sets the HP-IB Address

Selects an interface (HPIB or RS232)

Selects baud rate (300, 600, 1200, 2400, 4800, 9600)

Selects message parity (NONE, EVEN, ODD, MARK, SPACE)

Selects flow control (XON-XOFF, RTS-CTS, DTR-DSR,  NONE)

Selects language (SCPI or COMP)

Recalls instrument state

Saves present instrument state

Displays errors in SCPI error queue

Measures output voltage and current

Measures peak output voltage

1

Measures minimum output voltage

1

Measures the high level of a  voltage pulse waveform

1

Measures the low level of a  voltage pulse waveform

1

Measures rms voltage

1

Measures peak output current

1

Measures minimum output current

1

Measures the high level of a  current pulse waveform

1

Measures the low level of a  current pulse waveform

1

Measures rms current

1

Sets the output voltage

Sets the output current

Protection status (example shows overcurrent tripped)

Places the dc source in the factory-default state

Select the power-on state command (RST or RCL0)

Sets the output protection delay in seconds

Sets the remote inhibit mode (LATCHING, LIVE, or OFF)

Sets the discrete fault indicator state  (ON or OFF)

Selects the DFI source (QUES, OPER, ESB, RQS, or OFF)

Sets the output port functions (RIDFI or  DIGIO)

Sets and reads the I/O port value (0 through 7)

Sets the output relay state (ON or OFF)

 2

Sets the output relay polarity (NORM or REV)

 2

Sets overvoltage protection level

Sets current range (HIGH, LOW, or AUTO)

Sets current measurement detector (ACDC or DC)

1

Accesses calibration menu (See User’s Guide).

Use              and              to select menu parameters.      Use             to exit any menu and return to metering mode.

1

Not available on HP 6631B - 6634B or in Compatibility mode.                

2

Not available on HP 6631B.