Sharp DX-B350P ユーザーズマニュアル

You should set your printer Media Type to Thick1 or any of the other paper types that use 
Thick1 fuser mode for any paper that is from 106 gsm to 159 gsm. If your paper is 160 gsm to 
216 gsm, you should set your printer Media Type to Thick2 or Cardstock. If you do not get 
satisfactory results using Thick1 or Thick2 on some paper types with rough or uneven surfaces, 
it is possible you will get improved results using Thick3 on the DX-B450P because of the lower 
fuser temperature and slower paper speed in the printer.

The fuser temperature progression is 

DX-B350P:

 (Low) Transparency

 Normal

 Thick1

 Thick2 (High)  and 

DX-B450P: 

(Low) Transparency

 Thin

 Thick3

 Normal

 Thick1

 Thick2  (Low)

Transparencies can be printed from all trays, but they can not be printed on two sides using the 
Duplex Module. Only use transparencies designed for laser printers so they can withstand the 
heat required for fusing. It is possible to damage your printer by using unsupported 
transparencies.

Loading transparencies into the trays:

1. Remove the tray from the printer.

2. Remove all paper from a tray before loading transparencies.

3. Fan the stack of new transparencies before putting them in the tray.

4. Insert the transparencies into the tray. 

Place the transparencies in the input tray with the side to be printed facing up. Do not fully 
load a tray with transparencies. The printer supports loading 100 transparencies or less in 
a tray. Handle them by the edges with both hands and avoid getting fingerprints and 
creases on them.

5. Adjust the paper guides to fit the transparencies. 

6. Insert the tray firmly into the printer.

Using the Operator Panel or EWS, select the Transparency Media Type and correct Media 
Size for the tray to be used.

Thick 3 DX-B450P only

Thick3

No duplex
Half Speed on DX-B450P
Not available on DX-B350P

Thin (64-67 gsm) DX-B450P only

Thin

Not available on DX-B350P

Eliminate line space

Eliminate line space