Cognitive Solutions A776 ユーザーズマニュアル

A776 (B780) Programming Guide 

A776-PG00001 C 12/09

ESC Y n1 n2 d1 ... dn 

Hexadecimal  1B 59 n1 n2 d1 ... dn 

27 89 n1 n2 d1 ... dn 

Equivalent to 1B  2A  m=1  n1 n2 d1 ... dn

FS p n m 

Hexadecimal  1C 70 n m 
Decimal 

28 112 n m

Print flash logo ID n using mode m.  See command 1D 2F m for description of mode m.  See 
command 1C 71 for description of n. The select slip command x/C must be disabled via  
1F 03 38 00 to use this logo command.

FS q n  [xL xH yL yH d1 …dk]1…[xL xH yL yH d1 …dk]n 

Hexadecimal     1C 71 n  [xL xH yL yH d1 …dk]1…[xL xH yL yH d1 …dk]n 

28 113 n  [xL xH yL yH d1 …dk]1…[xL xH yL yH d1 …dk]n

Define n flash logos specified by IDs 1 through n.  Maximum size of logos is determined by 
amount of flash allocated to logos.  See command 1D 22 80… for flash allocation.The select slip 
command x/C must be disabled via 1F 03 38 00 to use this logo command.

0 < xH:xL < 1024  max printable xH:xL = 72 = 576 dots wide

0 < yH:yL < 256

For each logo definition:  xH:xL times 8 dots in the horizontal direction, yH:yL times 8 dots 
in the vertical direction.  Total data definition bytes k = xH:xL times  yH:yL times 8 bytes.  See 
command 1D 2A x y … for description of data definition bytes arrangement.

During execution of this command printer turns off USM and Real Time status processing.  The 
printer goes busy when writing to flash.  At the end of this command the printer resets.

GS # n 

Hexadecimal  1D 23 n 

29 35 n

0 – 255

0 

Selects a color or monochrome logo to be defined or printed. The active logo n remains in use until this command is 
sent again with a different logo n.

When this command precedes a logo definition, that definition is stored in flash memory as logo n. If there is already 
a different definition in flash memory for logo n, the first is inactivated and the new definition is used. The inactive 
definition is not erased from flash and continues to take up space in flash memory.

When this command precedes a logo print command and n is different from the previously active logo selected, the 
printer retrieves the logo definition for n from flash memory and prints it. If there is no definition for logo n, then no 
logo is printed.

In the case of a previously existing application that expects only one possible logo, the printer will not receive the 
select current logo (1D 23 n) command. In this case, the printer assigns 0 as the active logo identifier. It automatically 
stores any new logo definition in flash memory as logo 0, inactivating any previous logo 0 definition. If the flash 
memory space available for logos fills up with inactive logo 0 definitions, the firmware erases the old definitions at the 
next power cycle. This is the only case in which the printer erases flash memory without an application command.
Continued . . .