Vidikron 30 ユーザーズマニュアル

Amplitude: The Amplitude menu allows you to fine-tune the currently-selected image 
aspect ratio by stretching it horizontally or vertically, in small increments. This can be useful if 
your projector is equipped with an anamorphic lens. 

The Horizontal control adjusts the image width while keeping the height constant. Similarly, 
the Vertical control adjusts the image height while keeping the width constant. 

Horizontal Masking (Vision 30/CineWide and Vision 30ET/CineWide only): To achieve 
the proper image geometry with the secondary anamorphic lens, select Horizontal Masking 
from the Service menu. Then, use the 

 or 

 button to change the native aspect ratio of the 

display, in small increments. 

Fan Control: Select Fan Control from the Service Menu to control the operation of the 
projector’s cooling fan. 

• Mode: In most cases, the default Fan Control Mode (Auto Normal) will maintain the 

correct operating temperature. If the lamp frequently turns off due to overheating, or in 
certain high-altitude operating environments, you may need to change this setting to 
Auto Hi. Altitude or Manual. 

• Fan Speed: If you set the Fan Mode to Manual, select Fan Speed and use the on-screen 

slidebar to adjust the speed. 

After changing either of these settings, press EXIT to return to the previous menu.

Lamp Reset Timer: When you replace the projector lamp (refer to Lamp Replacement on 
page 53), you should also reset the lamp timer. To do this, select Lamp Reset Timer from the 
Service menu. Press the right-arrow key on the remote to highlight “Yes,” then press ENTER 
to confirm the reset. 

RS-232 Baud Rate: To change the data rate of the projector’s RS-232 input, select RS-232 
Baud Rate from the Service menu. Set it to either 9600, 38400 or 115200, to match the data 
rate of the computer or control system connected to the projector.