Barracuda Networks Network Hardware プリント

This Quick Start Guide will help you with the initial configuration of your Barracuda NG Firewall. It shows how to connect to your Barracuda NG Firewall, connect an Internet Service Provider, how to configure the 

firewall rule set to get a connection to the Internet, install your licenses and activate the unit. 

•  Connect an AC power cord to the Barracuda NG Firewall. 

.

•  Either use the crossover network cable (red) to directly connect to the management port of the 

appliance or use the standard network cable (grey) and connect to the same network switch as 

the Barracuda NG Firewall. 

The table below lists the default port configuration for certain appliance types. Models F10 to F30x 

have a pre configured WAN port to connect your ISP. Models F400 to F900 need to be configured 

manually.

F10

PORT1

PORT4

F100 / F101 

PORT1

PORT4

F200 / F201 

PORT1

PORT4

F300 / F301 

PORT1

PORT4

F400

PORT1

F600

PORT1

F800

1st port of left module

F900

MGMT

Since every Barracuda NG Firewall is shipped with a default network configuration it is necessary 

to configure your personal computer accordingly.

Launch the network adapter configuration dialog of your MS Windows operating system and modify 

the IPv4 configuration.

192.168.200.200

root

ngf1r3wall

Launch the NG Admin application located on the USB Thumb Drive shipped with your Barracuda 

NG Firewall. This application is used to manage your Barracuda NG Firewall.

Select 

, enter the default management IP address, the default user credentials, and click 

.

Internet

ISP Modem

PORT1

PORT4

NG Admin

192.168.200.0/24

.100

.200