Alcatel Carrier Internetworking Solutions 060187-10 REV D ユーザーズマニュアル
Configuring OSPF
OSPF Quick Steps
OmniSwitch 6600 Family Advanced Routing Configuration Guide
March 2005
page 1-5
9 Assign the OSPF interface to the area and the backbone using the
ip ospf interface area
command.
For example:
-> ip ospf interface 120.1.4.1 area 0.0.0.0
or
-> ip ospf interface vlan-5 area 0.0.0.0
10 Enable the OSPF interfaces using the
ip ospf interface status
command. For example:
-> ip ospf interface 120.1.4.1 status enable
or
-> ip ospf interface vlan-5 status enable
11 You can now display the router OSPF settings by using the
show ip ospf
command. The output gener-
ated is similar to the following:
-> show ip ospf
Router Id = 1.1.1.1,
OSPF Version Number = 2,
Admin Status = Enabled,
Area Border Router? = Yes,
AS Border Router Status = Disabled,
Route Redistribution Status = Disabled,
Route Tag = 0,
SPF Hold Time (in seconds) = 10,
SPF Delay Time (in seconds) = 5,
MTU Checking = Disabled,
# of Routes = 0,
# of AS-External LSAs = 0,
# of self-originated LSAs = 0,
# of LSAs received = 0,
External LSDB Limit = -1,
Exit Overflow Interval = 0,
# of SPF calculations done = 1,
# of Incr SPF calculations done = 0,
# of Init State Nbrs = 0,
# of 2-Way State Nbrs = 0,
# of Exchange State Nbrs = 0,
# of Full State Nbrs = 0,
# of attached areas = 2,
# of Active areas = 2,
# of Transit areas = 0,
# of attached NSSAs = 0
Router ID
As set in Step 5