ZyXEL Communications P-334W ユーザーズマニュアル

Prestige 334W User’s Guide 

Remote Node Configuration 

 

25-5 

The second is that the Prestige will try to bring up the connection when turned on and whenever the 
connection is down. A nailed-up connection can be very expensive for obvious reasons.  

Do not specify a nailed-up connection unless your telephone company offers flat-rate service or you need a 
constant connection and the cost is of no concern. 

The following table describes the fields not already described in Table 25-1. 

Service Name 

If you are using PPPoE encapsulation, then type the name of your 
PPPoE service here. Only valid with PPPoE encapsulation. 

poellc 

Authen  This field sets the authentication protocol used for outgoing calls. 

Options for this field are: 
CHAP/PAP - Your Prestige will accept either CHAP or PAP when 
requested by this remote node.  
CHAP - accept CHAP only.  
PAP - accept PAP only.  

CHAP/PAP 

Telco Option 

 

 

Allocated 

Budget 

The field sets a ceiling for outgoing call time for this remote node. The 
default for this field is 0 meaning no budget control.  

0 

(default) 

Period(hr)  This field is the time period that the budget should be reset. For 

example, if we are allowed to call this remote node for a maximum of 10 
minutes every hour, then the Allocated Budget is (10 minutes) and the 
Period(hr) is 1 (hour). 

0 

(default) 

Schedules  You can apply up to four schedule sets here. For more details please 

refer to the Call Schedule Setup chapter. 

Nailed-Up 

Connection 

This field specifies if you want to make the connection to this remote 
node a nailed-up connection. More details are given earlier in this 
section. 

(default) 

Session Options   

Idle Timeout  Type the length of idle time (when there is no traffic from the Prestige to 

the remote node) in seconds that can elapse before the Prestige 
automatically disconnects the PPPoE connection. This option only 
applies when the Prestige initiates the call. 

100 seconds 

(default)