ZyXEL Communications P-334W ユーザーズマニュアル

Prestige 334W User’s Guide 

Firmware and Configuration File Maintenance   

34-11 

To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware and the 
configuration file, follow the procedure shown next. 

Step 1.  Use telnet from your computer to connect to the Prestige and log in. Because TFTP does not have 

any security checks, the Prestige records the IP address of the telnet client and accepts TFTP 
requests only from this address. 

Step 2.  Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System 

Maintenance. 

Step 3.  Enter the command “sys stdio 0” to disable the console timeout, so the TFTP transfer will not be 

interrupted. Enter “command sys stdio 5” to restore the five-minute console timeout (default) 
when the file transfer is complete. 

Step 4.  Launch the TFTP client on your computer and connect to the Prestige. Set the transfer mode to 

binary before starting data transfer. 

Step 5.  Use the TFTP client (see the example below) to transfer files between the Prestige and the 

computer. The file name for the firmware is “ras”. 

Note that the telnet connection must be active and the Prestige in CI mode before and during the TFTP 
transfer. For details on TFTP commands (see following example), please consult the documentation of your 
TFTP client program. For UNIX, use “get” to transfer from the Prestige to the computer, “put” the other way 
around, and “binary” to set binary transfer mode. 

The following is an example TFTP command: 

tftp [-i] host put firmware.bin ras 

where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the 
Prestige’s IP address and “put” transfers the file source on the computer (firmware.bin – name of the 
firmware on the computer) to the file destination on the remote host (ras - name of the firmware on the 
Prestige). 

Commands that you may see in GUI-based TFTP clients are listed earlier in this chapter.