ZyXEL Communications P-334W ユーザーズマニュアル
Prestige 334W User’s Guide
6-8
LAN Screens
Table 6-1 IP
LABEL DESCRIPTION
Allow from LAN to
WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
Apply
Click Apply to save your changes back to the Prestige.
Reset
Click Reset to begin configuring this screen afresh.
6.6 Configuring Static DHCP
This table allows you to assign IP addresses on the LAN to specific individual computers based on their
MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is assigned at
the factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02.
To change your Prestige’s Static DHCP settings, click LAN, then the Static DHCP tab. The screen appears
as shown.
MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is assigned at
the factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02.
To change your Prestige’s Static DHCP settings, click LAN, then the Static DHCP tab. The screen appears
as shown.
Figure 6-3 Static DHCP
The following table describes the labels in this screen.