Peerless Industries HDS200 ユーザーズマニュアル

ISSUED: 07-24-12   SHEET #: 180-9023-1

1. POWER Button - Turns the Transmitter and Receiver power ON/OFF.

• 

ON: If the Transmitter and Receiver are powered off and the Power/Link Indicator Light is on, press 
the power button pointed at either unit to turn on both unit's at the same time (this will take about 30 
seconds). 

• 

ON: If the Transmitter and Receiver are powered off and the Power/Link Indicator Light is off, each unit 
will need to be turned on separately. Point the remote at each unit's IR Input port and press the power 
button to turn on (this will take about 1 minute and 30 seconds). 

• 

OFF: If the Transmitter and Receiver are powered on and the Power/Link Indicator Light is on, press the 
power button to turn off both units at the same time to put the system in Standby mode. The Power/Link 
Indicator Light will remain on.

• 

OFF: If the Transmitter and Receiver are powered on and the Power/Link Indicator Light is on, press 
and hold the power button for 8 seconds. Both Transmitter and Receiver will be turned off at the same 
time. The Power/Link Indicator Light will turn off.

 If the Transmitter and Receiver are powered on with the Power/Link Indicator Light fl ashing, both units 

will need to be powered off individually.

 - Displays the following information on the screen for:

• 

Transmitter ** - WiFi Channel, Firmware Version, Audio/Video Input, and Source Resolution.

• 

Receiver - Connection, Firmware Version, Video Output, Display Resolution, WiFi Reception Strength 
1/5 to 5/5 (where 1/5 is the weakest signal and 5/5 is the strongest signal).

Displayed information will disappear automatically after 10 seconds.

The Transmitter unit’s information will only be displayed if the connection between the Transmitter unit and 

Receiver has been established.