Lucent Technologies merlin messaging system ユーザーズマニュアル

This procedure is required only when the communication system is in the Key mode and is not needed in
the Hybrid/PBX mode. To ensure proper operation, the outside line assigned to the MERLIN Messaging
System voice port(s) that are used for Outcalling must be set to No Ring. This procedure is not necessary if
the communications system is operating in the Hybrid/PBX mode.

For MERLIN Messaging System Release 2 or later, the voice port(s) used for Outcalling are Port 2 on a
2-port system, Port 4 on a 4-port system, Ports 5 and 6 on a 6-port system, Ports 7 and 8 on an 8-port
system, Ports 9 and 10 on a 10-port system, or Ports 11 and 12 on a 12-port system. For Release 1 or 1.1,
the voice port used for Outcalling is Port 2 on a 2-port system, Port 4 on a 4-port sytem, or Port 6 on a
6-port system.

For MERLIN Messaging System Release 2 or later, the voice port(s) used for Outcalling are Port 2 on a
2-port system, Port 4 on a 4-port system, Ports 5 and 6 on a 6-Port system, Ports 7 and 8 on a 8-port system,
Ports 9 and 10 on a 10-port system, or Ports 11 and 12 on a 12-port system. For Release 1 or 1.1, the voice
port used for Outcalling is Port 2 on a 2-port system, Port 4 on a 4-port system, or Port 6 on a 6-port
system.

Enter Programming mode

 Sys Program

 Exit/Start

[any key]

Display next page of menu

/ 

Select Centralized Telephone
Programming

 Cntr-Prg

Select Program Extension

 Program Ext

Enter the extension you want to
program

[nnn]

 Enter

[nnn]

Start Centralized Telephone
Programming

 Start

Select the line/feature button
representing the Outcalling line

Press button on console

 

 

or

 

 +

function key, then 

Setting the Outcalling Lines to No Ring

http://www.sostc.com/lucent/ongoingmaintenance/portlicensing/mmipcpmp6.htm (1 of 2) [2/2/2000 2:35:40 PM]