Cisco Systems ASA 5500 ユーザーズマニュアル
Chapter 5 Configuring the Adaptive Security Appliance
Using the Startup Wizard
5-4
Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
78-17611-01
Using the Startup Wizard
ASDM includes a Startup Wizard to simplify the initial configuration of your
adaptive security appliance. With a few steps, the Startup Wizard enables you to
configure the adaptive security appliance so that it allows packets to flow securely
between the inside network (GigabitEthernet0/1) and the outside network
(GigabitEthernet0/0).
adaptive security appliance. With a few steps, the Startup Wizard enables you to
configure the adaptive security appliance so that it allows packets to flow securely
between the inside network (GigabitEthernet0/1) and the outside network
(GigabitEthernet0/0).
To use the Startup Wizard to set up a basic configuration for the adaptive security
appliance, perform the following steps:
appliance, perform the following steps:
Step 1
If you have not already done so, perform one of the following steps:
•
If you have an ASA 5520 or 5540, connect the inside GigabitEthernet0/1
interface to a switch or hub by using the Ethernet cable. To this same switch,
connect a PC for configuring the adaptive security appliance.
interface to a switch or hub by using the Ethernet cable. To this same switch,
connect a PC for configuring the adaptive security appliance.
•
If you have an ASA 5510, connect the inside Ethernet 1 interface to a switch
or hub by using the Ethernet cable. To this same switch, connect a PC for
configuring the adaptive security appliance.
or hub by using the Ethernet cable. To this same switch, connect a PC for
configuring the adaptive security appliance.
Step 2
Configure your PC to use DHCP (to receive an IP address automatically from the
adaptive security appliance), or assign a static IP address to your PC by selecting
an address out of the 192.168.1.0 network. (Valid addresses are 192.168.1.2 through
192.168.1.254, with a mask of 255.255.255.0 and default route of 192.168.1.1.)
adaptive security appliance), or assign a static IP address to your PC by selecting
an address out of the 192.168.1.0 network. (Valid addresses are 192.168.1.2 through
192.168.1.254, with a mask of 255.255.255.0 and default route of 192.168.1.1.)
Note
The inside interface of the adaptive security appliance is assigned
192.168.1.1 by default, so this address is unavailable.
192.168.1.1 by default, so this address is unavailable.
Step 3
Perform one of the following steps:
•
If you have an ASA 5520 or 5540, check the LINK LED on the
GigabitEthernet0/1 interface.
GigabitEthernet0/1 interface.
•
If you have an ASA 5510, check the LINK LED on the Ethernet 1 interface.
When a connection is established, the LINK LED interface on the adaptive security
appliance and the corresponding LINK LED on the switch or hub becomes solid
green.
appliance and the corresponding LINK LED on the switch or hub becomes solid
green.
Step 4
Launch the Startup Wizard.
a.
On the PC connected to the switch or hub, launch an Internet browser.