Multi-Tech Systems MVP210-SS ユーザーズマニュアル
MultiVOIP User Guide
QS: Startup Tasks
24
MultiVOIP Startup Tasks
Task
Summary
Collecting Phone/IP
Details ( vital! )
The MultiVOIP must be configured to
interface with your particular phone
system and IP network. To do so,
certain details must be known about
those phone and IP systems.
interface with your particular phone
system and IP network. To do so,
certain details must be known about
those phone and IP systems.
Placement
Decide where you’ll mount the voip.
Command/Control
Computer Setup:
Specs & Settings
Some modest minimum specifications
must be met. A COM port must be set
up.
must be met. A COM port must be set
up.
Hookup
Connect power, phone, and data cables
per diagram.
per diagram.
Software Installation
This is the configuration program.
It’s a standard Windows software
installation.
It’s a standard Windows software
installation.
Phone/IP Starter
Configuration
You will enter phone numbers and IP
addresses. You’ll use default parameter
values where possible to get the system
running quickly.
Use “Config Info CheckList” (page 28).
addresses. You’ll use default parameter
values where possible to get the system
running quickly.
Use “Config Info CheckList” (page 28).
Phonebook Starter
Configuration
The phonebook is where you specify
how calls will be routed. To get the
system running quickly, you’ll make
phonebooks for just two voip sites.
how calls will be routed. To get the
system running quickly, you’ll make
phonebooks for just two voip sites.
Connectivity Test
You’ll find out if your voip system can
carry phone calls between two sites.
That means you’re up and running!
carry phone calls between two sites.
That means you’re up and running!
Troubleshooting
Detect and remedy any problems that
might have prevented connectivity.
might have prevented connectivity.