Multi-Tech Systems MVP210-SS ユーザーズマニュアル

40 

 

Phonebook Starter Configuration (with remote voip) 

If the topic of voip phone books is new to you, it may be helpful to read 

the PhoneBook Tips section (page 47) before starting this procedure.   
To do this part of the quick setup, you need to know of another voip 

that you can call to conduct a test.  It should be at a remote location, 

typically somewhere outside of your building.  You must know the 

phone number and IP address for that site.  We are assuming here that 

the MultiVOIP will operate in conjunction with a PBX. 
You must configure both the Outbound Phonebook and the Inbound 

Phonebook.  A starter configuration only means that two voip locations 

will be set up to begin the system and establish voip communication. 

1. Open the MultiVOIP program.  

( Start | MultiVOIP xxx | Configuration ) 

2. Go to Phone Book | Outbound Phonebook | Add Entry. 
3. On a sheet of paper, write down the calling code of the remote voip 

(area code, country code, city code, etc.) that you’ll be calling. 

  Follow the example that best fits your situation. 

 

 

 

Technician in Seattle (area 

206) must set up one voip 

there, another in Chicago 

(area 312, downtown). 

: Write down 312. 

  Technician in central 

London (area 0207) to set 

up voip there, another in 

Birmingham (area 0121). 

r: write down 0121. 

 

 

 

   

 

 

 

 

 

 

Technician in Rotterdam (country 31; city 010) to 

set up one voip there, another in Bordeaux 

(country 33; area 05). 

: write down 3305.