Denon AVR-2312CI ユーザーズマニュアル
23
Set up speakers (Audyssey® Auto Setup)
14
Select “Store” and then press
ENTER
.
Save the measurement results.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
STEP6 Store
Now storing...Please wait.
20%
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
Store
STEP6 Store
Apply and store measurement result
Enter
Cancel
Press “Store” to store calculation results.
• Saving the results requires about 10 seconds.
• If the measuring results are not to be saved, press
• If the measuring results are not to be saved, press
RETURN
B
.
A message “Cancel auto setup?” will be displayed. Press
o then
select “Yes”. All the measured Audyssey® Auto Setup data will
be erased.
be erased.
• During saving of measurements results, “Now storing...Please
wait.” is displayed. When saving is completed, “Storing complete.
Auto Setup is now finished.” is displayed.
Auto Setup is now finished.” is displayed.
NOTE
During saving of measurement results, be sure not to turn off the
power.
power.
15
Unplug the setup microphone from the unit’s SETUP
MIC jack.
16
Set Audyssey Dynamic Volume®.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
No
Yes
Finish
Turn Dynamic Volume off and exit Auto Setup
Exit
Storing complete.
Auto Setup is now finished.
Please unplug microphone.
Turn on Dynamic Volume?
• This feature adjusts the output volume to the optimal level while
constantly monitoring the level of the audio input to the unit.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
Optimal volume control is performed automatically without any
loss in the dynamism and clarity of the sound when, for example,
the volume suddenly increases for commercials shown during
television programs.
n When turning Dynamic Volume® on
• Use
u to select “Yes”, and then press
ENTER
.
The unit automatically enters “Evening” mode.
n When turning Dynamic Volume® off
• Use
i to select “No”, and then press
ENTER
.
NOTE
After performing Audyssey® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey® Auto Setup again.
connections or subwoofer volume. In event of a change, perform
Audyssey® Auto Setup again.
STEP 6
Store
Finish
STEP 5
Check
12
Use
ui
to select the item you
want to check, and then press
ENTER
.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
Next Store
Crossover Freq. Check
Speaker Config. Check
Distance Check
Channel Level Check
STEP5 Check
Proceed to next (Store)
Enter
Cancel
Check processing results.
To proceed, press “Next”.
• Subwoofers may measure a greater reported distance than
the actual distance due to added electrical delay common in
subwoofers.
subwoofers.
• If you want to check another item, press
RETURN
B
.
13
Use
i
to select “Next → Store” and then press
ENTER
.
NOTE
• If the result differs from the actual connection status, or if “Caution!”
Audyssey® Auto Setup again.
• If you change speaker positions or orientation, perform Audyssey®
Auto Setup again to find the optimal equalizer settings.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
or
mation
Basic v
ersion