DELL 9.7(0.0) ユーザーズマニュアル
• High CPU utilization may be observed during an SNMP walk of a large BGP Loc-RIB.
• To avoid SNMP timeouts with a large-scale configuration (large number of BGP neighbors and a large
• To avoid SNMP timeouts with a large-scale configuration (large number of BGP neighbors and a large
BGP Loc-RIB), Dell Networking recommends setting the timeout and retry count values to a relatively
higher number. For example, t = 60 or r = 5.
• To return all values on an snmpwalk for the f10BgpM2Peer sub-OID, use the -C c option, such as
snmpwalk -v 2c -C c -c public<IP_address><OID>.
• An SNMP walk may terminate pre-maturely if the index does not increment lexicographically. Dell
Networking recommends using options to ignore such errors.
• Multiple BPG process instances are not supported. Thus, the f10BgpM2PeerInstance field in various
tables is not used to locate a peer.
• Multiple instances of the same NLRI in the BGP RIB are not supported and are set to zero in the SNMP
query response.
• The f10BgpM2NlriIndex and f10BgpM2AdjRibsOutIndex fields are not used.
• Carrying MPLS labels in BGP is not supported. The f10BgpM2NlriOpaqueType and
• Carrying MPLS labels in BGP is not supported. The f10BgpM2NlriOpaqueType and
f10BgpM2NlriOpaquePointer fields are set to zero.
• 4-byte ASN is supported. The f10BgpM2AsPath4byteEntry table contains 4-byte ASN-related
parameters based on the configuration.
Traps (notifications) specified in the BGP4 MIB draft <draft-ietf-idr-bgp4–mibv2–05.txt> are not
supported. Such traps (bgpM2Established and bgpM2BackwardTransition) are supported as part of RFC
1657.
supported. Such traps (bgpM2Established and bgpM2BackwardTransition) are supported as part of RFC
1657.
Configuration Information
The software supports BGPv4 as well as the following:
• deterministic multi-exit discriminator (MED) (default)
• a path with a missing MED is treated as worst path and assigned an MED value of (0xffffffff)
• the community format follows RFC 1998
• delayed configuration (the software at system boot reads the entire configuration file prior to sending
• a path with a missing MED is treated as worst path and assigned an MED value of (0xffffffff)
• the community format follows RFC 1998
• delayed configuration (the software at system boot reads the entire configuration file prior to sending
messages to start BGP peer sessions)
The following are not yet supported:
• auto-summarization (the default is no auto-summary)
• synchronization (the default is no synchronization)
• synchronization (the default is no synchronization)
BGP Configuration
To enable the BGP process and begin exchanging information, assign an AS number and use commands
in ROUTER BGP mode to configure a BGP neighbor.
By default, BGP is disabled.
By default, the system compares the MED attribute on different paths from within the same AS (the bgp
always-compare-med command is not enabled).
By default, the system compares the MED attribute on different paths from within the same AS (the bgp
always-compare-med command is not enabled).
NOTE: All newly configured neighbors and peer groups are disabled. To enable a neighbor or peer
group, enter the neighbor {ip-address | peer-group-name} no shutdown command.
group, enter the neighbor {ip-address | peer-group-name} no shutdown command.
The following table displays the default values for BGP in the Dell Networking OS.
Border Gateway Protocol IPv4 (BGPv4)
167