DELL 9.7(0.0) ユーザーズマニュアル

------ ------ ----------- --- ---- --------- --------

1 remote-vlan 10 Te 0/3 N/A N/A N/A N/A

2 remote-vlan 20 Te 0/4 N/A N/A N/A N/A

3 remote-vlan 30 Te 0/5 N/A N/A N/A N/A

Dell#

Configuring RPM Source Sessions to Avoid BPD Issues

When you configure an RPM source session, you can avoid BPDU issues by using the configuration:

Enable the MAC control-plane egress ACL.
mac control-plane egress-acl

Create an extended MAC access list and add a deny rule for (0x0180c2xxxxxx) packets using the
following commands:
mac access-list extended mac2

seq 5 deny any 01:80:c2:00:00:00 00:00:00:ff:ff:ff count

Apply the extended MAC ACL on the RPM VLAN (VLAN 10 in the following example).
Dell#show running-config interface vlan 10

interface Vlan 10

no ip address

mode remote-port-mirroring

tagged Port-channel 2

mac access-group mac2 out

no shutdown

Create an RPM session (In the following example, port-channels 1 and 2 are LACP).
Dell(conf)#monitor session 1 type rpm

Dell(conf-mon-sess-1)#source port-channel 1 destination remote-vlan 10

dir rx

Dell(conf-mon-sess-1)#no disable

Verify the port-channel configuration.
Dell#show interfaces port-channel brief

Codes: L - LACP Port-channel

O - OpenFlow Controller Port-channel

LAG Mode Status Uptime Ports

L1 L3 up 00:01:17 Te 0/44 (Up)

L2 L2 up 00:00:58 Te 0/45 (Up)

Dell#

Port Monitoring

695