Patton electronic 3120 ユーザーズマニュアル

Configuring the RAS with a Web browser

Model 3120 RAS Getting Started Guide 

14. Click on 

.

signaling is now configured for MFC-R2.

The information entered into the Interregister Signaling section must 
match the information the telco provided. If the information entered 
is not the same, the RAS may not answer calls. In some installations, 
the phone company will send a special tone to alert that it is done 
sending the Calling Number. In this case, the value in the Total Dig-
its box does not have to match the telephone company’s exactly.

Channel assignment
This section describes configuring the RAS so it will know which channels are active. Do the following:

1. Select 

T1/E1 Link

 on the 

Configuration Menu

. The T1/E1 Link Activity window appears (see figure 28 on 

2. Click on 

Channel Assignment

. The WAN Circuit Channel Assignment window appears (see figure 33).

Figure 33. WAN Circuit Channel Assignment window

3. Click on the 

 button located under 

Set all channels to:

.

4. Click on 

.

1. Select 

T1/E1 Link

 on the 

Configuration Menu

. The T1/E1 Link Activity window appears (see figure 28 on 

Link: 1

 corresponds to Line 1 on the RAS. This is the primary link for dial-in callers. Under Link 1, Click 

on 

Configuration

 then 

Modify

. The Line Interface Settings section of the WAN Circuit Configuration 

window appears (see figure 29 on page 41).