Toshiba NB200 ユーザーズマニュアル

User’s Manual

6-9

Power and Power-up Modes

■

Disconnect the AC adaptor when the battery is fully charged -

overcharging will make the battery hot and can shorten its operating life.

■

If you are not going to use the computer for more than eight hours,

disconnect the AC adaptor.

■

Store spare battery packs in a cool dry place out of direct sunlight.

Replacing the battery pack

Please be aware that the battery pack is classified as a consumable item.
The operating life of the battery pack will gradually reduce through

repeated charging and discharging, and will need to be replaced when it

reaches the end of its operating life. In addition to this, you might also

replace a discharged battery pack with a charged spare when you are

operating your computer away from an AC power source for an extended

period of time.
This section explains how to remove and install the battery pack, and

begins with the removal process which is detailed through the following

steps.

To remove a discharged battery, follow the steps as detailed below:
1. Save your work.
2. Turn the computer's power off - ensure that the Power indicator is off.
3. Remove all cables and peripherals that are connected to the computer.
4. Close the display panel and turn the computer upside down.

■

Do not remove the battery pack while the computer is in Standby Mode.

Data is stored in RAM, so if the computer loses power it will be lost.

■

In Hibernation Mode, data will be lost if you remove the battery pack or

disconnect the AC adaptor before the save is completed. Wait for the

Hard Disk Drive indicator to go out.

■

Do not touch the battery release latch while holding the computer or the

battery pack might fall out due to the unintentional release of the

battery release latch and cause injuries.