Nortel Networks AN/DC ユーザーズマニュアル
Installing and Operating AN/DC and ANH-8/DC Systems
2-12
312410-A Rev 00
Connecting Communications Cables
Gather the communications equipment and cabling that you will attach to the
ANH-8/DC. If you do not have the proper cables, contact your network
administrator or see the Cable Guide for Routers and BNX Platforms. Appendix C
describes the ANH-8/DC cable interfaces.
ANH-8/DC. If you do not have the proper cables, contact your network
administrator or see the Cable Guide for Routers and BNX Platforms. Appendix C
describes the ANH-8/DC cable interfaces.
Connecting an AUI Cable
Complete these steps to connect an Ethernet AUI transceiver cable to the front of
the ANH-8/DC:
the ANH-8/DC:
1.
Connect an Ethernet AUI drop cable to the port labeled AUI (
The cable must have a female 15-pin DSUB connector.
Figure 2-7.
Connecting an AUI Cable
2.
Secure the AUI cable using the connector slide lock.
3.
Connect the other end of the cable to the transceiver device.
Note:
Connecting the ANH-8/DC AUI port directly to the AUI port on an
Ethernet station violates IEEE 802.3 standards. The AUI port is designed only
for connection to a transceiver.
for connection to a transceiver.
Reset
Partition
Link
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Console
Power
Fault
Boot Run DCM AUI Part
DCD1 DCD2 <LAN> Col
AUI
MDI-X/MDI
MDI-X
AUI cable
AUI interface
AN0044A