Citizen CL-S700R ユーザーズマニュアル

 3-33 

Disassembly procedures for the Rewinder part of CL-S700R are explained here. 
 
[Parts to be lubricated] 
When the following parts are replaced or reassembled, apply grease (Floil G-311S).   
The places to be lubricated are indicated with the mark  in the drawings for the Rewinder Part 
(the latter half) of Chapter 5 “Parts List”.   

 
Drawing No. 2 “Unit, Rewinder”: 
•  ”Shaft, Measure Sensor” [2-1]: Both ends of the shaft (2 places) 
•  ”Shaft, Damper” [2-6]: Both ends of the shaft (2 places) 
•  “SA, Rewinder Motor” [2-8]: Contacting surface with the “Guide, Motor Plate” [2-10] (1 place) 
•  “Guide, Motor Plate” [2-10]: Back surface (1 place) 
•  “Shaft, Handle Plate” [2-24]: Both ends of the shaft (2 places) 
•  “Plate, Handle” [2-28]: Both holes for the “Shaft, Handle Plate” [2-24] (2 places) 
•  “SA, Handle Link” [2-29]: Both studs (2 places) 

• “Frame, Door L” [2-33]: “Shaft, Door” [2-40] (1 place)

 

• “Frame, Door R” [2-43]: “Shaft, Door” [2-40] (1 place) 

•  “Holder, Door Shaft R” [2-44]: Hole for “Shaft, Door” [2-40] (1 place) 
 
Drawing No. 3 “SA1, Peeler”: 
•  “Roller, Idle Rewinder” [3-1]: Both ends of the shaft (2 places) 
•  “Bush, Idle” [3-2]: Right side (2 places) 
•  “Roller, Friction” [3-6]: Both ends of the shaft (2 places) 

• “Plate, Sensor Holder” [3-8]: Rear surface at both ends where circled with a dotted line (2 

places) 

 
Drawing No. 4 “SA2, Peeler”: 
•  “Roll, Peel” [4-1]: Both ends of the shaft (2 places)