Microboards Technology II ユーザーズマニュアル

    

                                                                        Orbit II Disc-to-Disc Copier Reference Manual – Revision I

 

 

18 

 
 

There are two ways to control how many copies Orbit II makes.  If Ask Quantity? is turned off, you control the 
number of discs produced during each job by placing the appropriate number of blank CD-Rs or CD-RWs  
in the Input Hopper.   Orbit II stops copying when its Input Hopper is empty.  Remember that there is always  
the possibility of a reject.  If you need a specific number of copies, place one extra blank disc in the Input 
Hopper.  If Ask Quantity? is turned on, you control the exact number of copies produced by setting Orbit II’s 
counter at the start of each job.  (Refer to Section 7 for details.)   
 
Orbit II’s Input Hopper can hold a maximum of 50 CD-R or CD-RW discs.  Always load the first 5 or 6 CD-Rs on 
the Singulator Plate and Rear Support Ledge. The discs will be horizontal if loaded properly. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
If the duplication job requires more than 5 or 6 CD-Rs, load the remaining CD-Rs, leaning against  
the Stepped Guide Rod.  You can load up to a maximum of 50 CD-Rs in the Input Hopper. 

First 5-6 CD-Rs

 

First 5 or 6 CD-Rs

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
The Singulator will separate the bottom disc from the stack and feed it into the CD-R Writer.  The horizontal 
discs will move down.  The stack that is leaning against the Stepped Guide Rod may not drop a disc each