Louisville Tin and Stove VFM303 ユーザーズマニュアル

STEP 1. Remove wall mounting bracket from back of
heater.
STEP 2. Locate wall stud.
STEP 3. Attach wall mounting bracket to wall stud
with top at desired height, using (2) screws provided.
Make sure top of bracket is level.  See Figure 2.
STEP 4. Hang top of heater on wall mounting bracket.
STEP 5. Remove bottom front panel.
STEP 6. Secure back of heater to wall, utilizing
anchors (if necessary) or wood screws.  See Figure 3.

STEP 1. Remove wall mounting bracket from back of
heater.
STEP 2. Locate two studs.
STEP 3. Attach wall mounting bracket to wall studs with
top at desired height using (2) wood screws provided.
Make sure top of bracket is level.  See Figure 4.
STEP 4. Hang top of heater over wall mounting bracket.
STEP 5. Remove bottom front panel.
STEP 6. Secure back of heater to wall, utilizing anchors (if
necessary) or wood screws.  See Figure 3.

Wall Mounting Bracket

Wall Stud

FIGURE 4

HOLES FOR MOUNTING BACK OF

HEATER TO WALL

FIGURE 3

Page 9

HEATER

Make sure this cut-out
faces back of heater.

STEP 1. Remove floor base from carton.
STEP 2. Align screw holes in base to holes in heater
bottom.
STEP 3. Make sure that cut-out in top of floor base aligns
with cut-out in bottom of heater and the other cut-out in
bottom of heater and the other cut-out in base if facing
towards back of unit (see illustration below).
STEP 4. Attach floor base to bottom of heater using four
#8 screws (provided).

NOTE:

Floor bases are for use on VFM10, VFT10, VFM-

20, VFT-20,  VFM30 and VFT30 only.  The VFM6 Series has
no base and is not approved for use with one.

WALL STUD

    WALL
MOUNTING
BRACKET

FIGURE 2