Louisville Tin and Stove VFM63 ユーザーズマニュアル
Apply Air
STEP 3 - PILOT CLEANING
MAINTENANCE
The entire heater should be checked and cleaned by a qualified service person before the start of each
heating season. More frequent cleaning may be required due to excessive lint conditions from carpeting,
bedding material, etc.
heating season. More frequent cleaning may be required due to excessive lint conditions from carpeting,
bedding material, etc.
CABINET
To clean the cabinet and hearth and jamb assemblies of your heater, turn off and allow to cool, then wipe
with a soft damp cloth. This will remove any dust. Never use metal polish, furniture wax, or any type of
cleaning solution as this could cause odors when the heater is turned back on.
with a soft damp cloth. This will remove any dust. Never use metal polish, furniture wax, or any type of
cleaning solution as this could cause odors when the heater is turned back on.
MAIN BURNER
Burners may be cleaned by using a low pressure air hose, or soft brush. Be careful not to damage the
ceramic plaque.
ceramic plaque.
ODS/PILOT
STEP 1.
Remove bottom front panel.
STEP 2.
Disconnect pilot line from pilot.
STEP 3.
Use a low pressure air hose to blow through pilot and through ODS opening in side of pilot.
WARNING: Never insert anything into any of the openings in the pilot as this could damage the Oxygen
Depletion System and expose the homeowner to Carbon Monoxide poisoning.
Depletion System and expose the homeowner to Carbon Monoxide poisoning.
WARNING: After any servicing or cleaning make sure heater is completely re-assembled and check for
gas leaks.
gas leaks.
Page 16