Lennox Hearth 3-Piece Louver Kit プリント

P/N 750,119M ReV. B 03/2008

Merit, Merit Plus or elite Gas Fireplaces -

converting louvered fireplace to louvered or clean face to louvered-

Step 1. Remove the protective plastic covering from the louver assem-

blies.

Step 2. Grasp the existing top radiant panel / hood assembly or louver as-

semby and slightly lift and pull it forward away from the fireplace.

See Figure 3 for radiant panel assembly and Figure 2 for Louvered

assembly.

Step 3. Hang the replacement top louver assembly in the opening.

Step 4. Slide the existing hood into the slots on the lower edge of the cabinet

top flange. See Figure 2.

Step 5. Open the bottom radiant panel or louver assembly by pushing in

simultaneously the left and right sides of the panel or assembly.

(The radiant panel or assembly is hinged at the bottom).

Step 6. Merit Models - Remove the assembly from the fireplace by removing

the hinge screw and spacer at each end.

Merit Plus or ELite Models - Remove the bottom radiant panel or

louver assembly from the fireplace by sliding the hinge pin, located

at the radiant panel’s left side, to the right until it disengages from

the left corner post hole. Pull the door diagonally to the left, away

from the fireplace. Note: Reverse the use of the words “left” and

“right” for EDCR models.

cAUTiON

iNSTALL ONLY WHeN THe FiRePLAce iS OFF AND cOLD!

iMPORTANT NOTe

(Polished Brass & Brushed Stainless Kits Only): The finish on

the polished brass and brushed stainless louvers will require

heat to harden and cure (after approximately 3 fires, the finish

will be completely cured). Prior to burning this appliance, the

polished brass and brushed stainless surfaces should be cleaned

thoroughly with a good window cleaning solution and a soft

cloth. Do not use any metal polishes or abrasives to clean the

surfaces. Any oils or fingerprints left on the finish during the

curing process may become permanent blemishes.

Step 7. Snap the replacement nameplate logo into the 2 holes provided in

the replacement louver assembly. Note: This is not applicable to

the short panel of the EDPF, EDCR, EDCL models.

Step 8. Merit Models - Install the replacement bottom louver assembly

using the existing hinge screws and spacers.

Merit Plus or ELite Models - Install the replacement bottom louver

assembly by inserting the right side locating pin into the right cabinet

corner post and then the left side spring-loaded pin into the left

cabinet corner post. Note: Reverse the use of the words “left” and

“right” for EDCR models.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design,

materials, specifications, prices and the discontinuance of colors, styles and products.

Consult your local distributor for fireplace code information.

1110 West Taft Avenue • Orange, cA 92865