ZyXEL Communications 1111 ユーザーズマニュアル
Z-Wave Series Programming Guide
13
C
H A P T E R
3
SHD1111 Programming
3.1 Z-Wave Group (Association Command Class Version 2)
The SHD1111 supports one association group with five nodes. When the SHD1111 is triggered, all
devices associated with the SHD1111 will receive the relevant reports.
devices associated with the SHD1111 will receive the relevant reports.
3.1.1 Tamper Event Report (Alarm Report)
Press and hold the tamper switch on the back of the SHD1111 for more than 10 seconds, then
release it. The SHD1111 will send ALARM REPORT command to the nodes of Grouping 1 to inform
them there is a tamper event.
release it. The SHD1111 will send ALARM REPORT command to the nodes of Grouping 1 to inform
them there is a tamper event.
3.1.2 Control other Z-Wave Devices
When door/window is opened, the SHD1111 will send BASIC_SET command which contains an
adjustable value to the nodes of Grouping 2. For instance, the brightness level of a lamp can be
fixed according to the set value.
adjustable value to the nodes of Grouping 2. For instance, the brightness level of a lamp can be
fixed according to the set value.
However, the BASIC_SET command will be also sent to the nodes of Grouping 1. For instance, a
lamp module will be turned off after receiving the BASIC_SET command.
lamp module will be turned off after receiving the BASIC_SET command.
3.1.3 Z-Wave’s Configuration
3.1.3.1 Basic Set Level
The SHD1111 can send a Basic Set Command (set with a value) to a receiving device for the device
to operate in a certain way. For instance, a lamp receives the Basic Set command which the value is
decisive to the brightness (dim level) of this lamp.
to operate in a certain way. For instance, a lamp receives the Basic Set command which the value is
decisive to the brightness (dim level) of this lamp.
The following parameters are used in this example:
ALARM_REPORT Command
[Command Class Alarm, Alarm Report, Alarm Type = 0x01, Alarm Level = 0x11]
Basic Set Command
Event Present:
[Command Class Basic, Basic Set, Value = 255 (0xFF)]
Event Clear
[Command Class Switch Binary, Switch Binary Report, Value = 0x00(0)]