Nilfisk Alto 05210G ユーザーズマニュアル

 Operator's Manual - 

How To Operate the Squeegee 
(“S Class” models only)
The squeegee wipes the fl oor while the vacuum motor removes the 
dirty solution from the fl oor.  Use your right hand to lower or raise the 
squeegee handle.  To operate the squeegee, follow this procedure:
1.  To lower the squeegee and start the vac motor move the 

squeegee lever to the right and down.  See fi gure #12.

2.  To raise the squeegee, lift the squeegee lever up.  See fi gure 

#13.

Make sure water or solution does not enter the opening for the 
vacuum motor See fi gure #14.

The solution tank can be fi lled in the front or through the clear drain 
hose at the rear of the machine. To fi ll the solution tank follow this 
procedure:
1.  Remove the solution tank lid.  See fi gure #15.
2.  Fill the solution tank with water.
3.  Add a cleaning chemical to the water.  for the correct amount, 

follow the directions shown on the container.

Water solutions or cleaning materials used with this type of 
machine can leave wet areas on the fl oor surface.  These 
areas can cause a dangerous condition for the operator or 
other persons.  Always put CAUTION signs near the area you 
are cleaning.

Machines can ignite fl ammable materials and vapors.  Do not 
use with or near fl ammables such as gasoline, grain dust, 
solvents, and thinners.  Only use a cleaning concentration 
recommended by the chemical manufacturer.

Nilfi sk Alto recommends a maximum water temperature of 
120°F(49°C)

4.  Replace the solution tank lid.
5. When 

fi lling the machine from the rear, position the clear drain 

hose against bracket and insert hose as shown in fi gure 16.  
Solution level can be viewed from the back of the machine.