SVAT Electronics CLEARVU11 ユーザーズマニュアル

now you can see

CLEARVU11

20

The Clearvu11 has bulit in motion detection available for each camera . Press ENTER or +/- to check/uncheck this 

item. The default setting is “” - checked.

 

This is the link used to setup the motion settings for this camera. Press ENTER on Settings to call up Motion Setup 

menu for the camera.

In Camera Setup, press ENTER to 

call up Motion Setup as shown 

when the highlighted option is 

Settings in the motion setup row 

for the camera you wish to setup. 

The Motion setup allows you to 

define how the system responds 

to detected motion for the 

selected  camera.

Following is a brief description for each item and its specific operations:

•  Duration – response duration to define how long the DVR will record after motion is detected for this camera. 

Press +/- buttons to adjust the value (3 seconds - 60 minutes, or discrete).

•  Goto Preset – to define the preset position to go to if motion is detected (only works with PTZ cameras). For 

more details about preset locations, please refer to

 

PTZ Control

.

•  Pre-record – will define how long before motion is detected this camera will record at pre-record IPS. Press 

+/- buttons to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record time may be 

shorter than the value set if the total size of the pre-record pictures exceeds the pre-record buffer size of the 

system.

•  Post-record – will define how long after motion is detected this camera will record at the set Event Record 

IPS. Press +/- buttons to adjust the value (0 second - 60 minutes,  or discrete).

•  Alarm Out – will define which Alarm Output will be triggered when motion of this camera is detected. Press 

+/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).