Electrolux EIED2CAQS オーナーマニュアル
16
Solutions to Common Problems
Avoid Service Checklist
Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this dryer.
the result of defective workmanship or materials in this dryer.
OCCURRENCE
POSSIBLE CAUSE
SOLUTION
Dryer does not
start.
start.
Electrical power cord is not securely plugged in
or plug may be loose.
or plug may be loose.
Make sure the plug fits tightly in wall outlet.
House fuse blown or circuit breaker tripped.
Reset circuit breaker or replace fuse.
Make sure electrical line is not overloaded and the
dryer is on a separate circuit.
dryer is on a separate circuit.
Dryer runs but
won’t heat.
won’t heat.
There are 2 house fuses in the dryer circuit. If 1
of the 2 fuses is blown, the drum may turn but the
heater will not operate.
of the 2 fuses is blown, the drum may turn but the
heater will not operate.
Replace fuse.
Drying cycle takes
too long, outside of
the dryer feels too
hot or smells hot.
too long, outside of
the dryer feels too
hot or smells hot.
Lint filter is clogged with lint.
Make sure all lint has been removed from the dryer lint
filter before starting each cycle.
filter before starting each cycle.
Electric dryer is connected to a 208 volt circuit.
Drying time will be 20% longer than drying on a 240
volt circuit.
volt circuit.
Drying procedures have not been followed.
See “Operating Instructions.”
High humidity.
Use a dehumidifier near the dryer.
Dryer stops during
a cycle and
a cycle and
symbol is lit on
console.
console.
Water tank was not emptied between cycles
and is full.
and is full.
Empty water tank and continue cycle.
Excessive wrin-
kling.
kling.
Dryer is overloaded.
Do not overload. See “Operating Instructions.”
Items left in dryer too long.
Remove items as soon as cycle ends.
Insufficient sorting of items.
See “Operating Instructions.”
Drying temperature too high.
Follow fabric care label instructions.
Scratching or chip-
ping of the drum
finish.
ping of the drum
finish.
Foreign objects such as coins, pins, clips or
buttons are inside the dryer.*
buttons are inside the dryer.*
Always remove foreign objects from pockets before
laundering. Remove objects from drum and restart
dryer.
laundering. Remove objects from drum and restart
dryer.
Permanently attached items such as belt
buckles, zippers and fasteners may be hitting
the inside of the drum.*
buckles, zippers and fasteners may be hitting
the inside of the drum.*
It may be necessary to sew a scrap of material se-
curely around ornaments before drying to prevent
scratching and damage to the dryer.
curely around ornaments before drying to prevent
scratching and damage to the dryer.
*Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.