Universal Remote Control A6 ユーザーズマニュアル
Page 13
If Auto Search did not work, try this:
Programming URC-A6
using the Learning Method
STEP 1: Line up the URC-A6 to the remote control you
want to ‘learn’ from, head--to--head as shown below.
Make sure the heads are one to two inches apart.
want to ‘learn’ from, head--to--head as shown below.
Make sure the heads are one to two inches apart.
STEP 2: On the URC-A6, press the Component
button that you want to program (in this case the
button that says TV) and the ENTER [ENT] button at
the same time. Hold down both buttons for 2
seconds until the TV Component button light turns
on. This signals that you are in programming mode.
button that you want to program (in this case the
button that says TV) and the ENTER [ENT] button at
the same time. Hold down both buttons for 2
seconds until the TV Component button light turns
on. This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 3: Press any button on the URC-A6 that you
want to teach a command to. For example, if you
want to teach the MUTE button on the URC-A6 the
TV Mute command from the other remote, first
press the MUTE button on the URC-A6 and the TV
component button LED light will blink once
indicating that the URC-A6 is ready to learn the
command.
want to teach a command to. For example, if you
want to teach the MUTE button on the URC-A6 the
TV Mute command from the other remote, first
press the MUTE button on the URC-A6 and the TV
component button LED light will blink once
indicating that the URC-A6 is ready to learn the
command.
STEP 4: Press and hold the MUTE button on the
other remote until the component button LED on
the URC-A6 blinks twice. Now you can continue
learning all other buttons from your old remote by
pressing the next button on the URC-A6 and
repeating this step.
other remote until the component button LED on
the URC-A6 blinks twice. Now you can continue
learning all other buttons from your old remote by
pressing the next button on the URC-A6 and
repeating this step.
Note: The component LED will blink five times if
there was an error in the learning process. In this
case, please repeat Steps 3 and 4.
there was an error in the learning process. In this
case, please repeat Steps 3 and 4.