Universal Remote Control A6 ユーザーズマニュアル

Page 26

You can erase a single learned command, all
learned commands in each component mode,
SimpleSound programming, MacroPower
commands, or re-set the remote to original factory
default settings. 

Erasing a Single Learned Command from 
One Component

STEP 1: Press the component button where the
learned command is stored and the ENTER
buttons at the same time for two seconds until the
component LED light turns on. 

IMPORTANT: You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.

STEP 2: Press and hold the button you want to
erase for two seconds. The component LED light
will blink twice to confirm the erasure. 

STEP 3: Repeat Step 2 to erase any other buttons
in the selected component mode.

STEP 4: To exit Erase mode, press and hold both
the component button and the ENTER (ENT)
button at the same time until the component LED
light blinks three times.

COMPONENT

BUTTONS

ENTER