Radio Shack 15-133 ユーザーズマニュアル

If you have set up the remote using the 
procedure in “Searching for a Code,” you 
may want to know which five-digit code is 
operating your equipment.

1. On the remote control, press a device key 

once (TV, CBL/SAT, DVD, VCR or AUD); 
it blinks once. Then press and hold P until 
the device key blinks twice.

2. Enter 9 9 0. The device key blinks twice.
3. To find the first digit of the code, press 1 

once. Count the number of times the LED 
blinks and write down the number. 

  If the LED blinks once, the first digit is 1, 

if it blinks twice, the first digit is 2, etc. If 
a code digit is 0, the selected device key 
does not blink. 

4. Repeat step 3 four more times for the 

remaining digits, pressing 2 to find the 
second digit, 3 to find the third digit, 4 to 
find the fourth digit, and 5 to find the fifth 
digit. Write down the rest of the code and 
keep it in a safe place.

Your remote comes preset with the volume 
locked to the TV mode. This configuration 
allows you to control the volume of the TV 
while in the CBL/SAT, DVD or VCR modes.  
However, you may change the Volume Lock 
setting to Global Volume Lock to a different 
mode so that volume control is always 
controlled through your audio receiver.  After 
that, you can perform Individual Volume 
Unlock on a selected device to set its volume 
control for independent operation.

1. Press and hold P until the LED blinks 

twice, then release.

2. Enter 9 9 3. The LED blinks twice.
3. Press the device key for the device you 

wish to control volume (for example, TV). 
The LED blinks twice.