Shoprider Scootie ユーザーズマニュアル

9/22/2004 

8

 
 
Armrest Width Adjustments (Fig. 9) 
On the underside of the seat there are two hand 
knobs, one on each side.  Loosening the arm rest 
tightening knob allows the armrest width to be 
adjusted or arm rests to be removed. 

 
 
 
 
 
 
 

 
Armrest Angle Adjustment (Fig. 10) 
Flip up the armrests to allow access to the 
adjustment screw and lock nut, unscrew the lock 
nut and screw the bolt in or out to increase or 
decrease the angle.  Re-tighten the lock-nut. 
Your scooter is dispatched from the factory with 
the armrests set parallel to the floor. 
 
Scooter Length Adjustment (For Scootie & 
Sunrunner S ) (Fig. 11) 
The wheel base can be lengthened or shortened 
depending on its existing settings.  The standard 
length of the scooter can be extended up to 3 
inches.  To adjust the wheelbase, remove the 
seat and the chassis cover complete with 
integral batteries.  Remove the locking pin 
located at the front of the seat post (Fig. 8).  
Unscrew the red hand lever in front of the pin 
by turning counter-clockwise.  Loosen the clips 
that secure the wires along the chassis.  Slide the 
inner front section until the location holes 
become aligned.  Insert the locking pin and 
tighten the red hand lever, insuring when fully 
secured, the lever is facing the seat post as 
shown in Fig. 11. Replace the chassis cover with 
the integral batteries then replace the seat. 
 
Scooter Width Adjustment (For XtraLite 3) 
(Fig. 12) 
Remove seat as described above.  Remove rear 
basket.  Remove U-shaped pins, adjust wheels 
to proper hole.  Replace U-shaped pins.   
 

 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Figure 9 

Figure 10 

Figure 11 

 

 

Figure 12 

Extend both 
sides up to 3 
inches.

Locking Nut 
and Bolt

Arm Rest 
Adjustment 
Hand Knob

Adjustment 
Screw

Wheel Base 
Locking Pin

U- Shaped 
pins