Nady Systems ADI-2 ユーザーズマニュアル

Congratulations for purchasing the ADI-2 2-Channel Active Direct Inject Box. This unique
unit is the ultimate, multi-functional active DI box. The ADI-2 is indispensable for solving
many audio mismatch and hum problems in numerous stage and studio applications.

• Simultaneous dual inputs and outputs for stereo or multi-source use
• Eliminates impedance mismatch problems and converts any sound source at

almost any level (from guitar to speaker) into a clean, powerful hum-free, noise-
free and interference-free balanced signal perfect for even extremely long cable
runs

• Full-featured controls and connections include On/Off, Ground Lift, and Guitar/

Speaker Source Select input attenuation switches; unbalanced 1/4" TS Input and
Parallel Link Output jacks; and servo-balanced XLR Output jack.

• Parallel link output allows ultimate hookup flexibility by enabling applications such

as connection to the input of the backline or monitor amplifier.

• No compromise circuit design and stringent component selection provide

absolutely flat, full frequency response across the entire audio spectrum, and
negligible distortion for the most natural, powerful audio available.

• Portable aircraft aluminum extruded case for ultimate roadworthiness, long life and

reliability

• Powered either by console’s +48V phantom power or internal 9V battery

Introduction ......................................................................................................................... 2

Controls and Connections .................................................................................................. 3

Operations .......................................................................................................................... 4

Connected to Instrument ............................................................................................. 5

Connected to Amplifier ................................................................................................ 5

Specifications ..................................................................................................................... 5

......................................................................................... 10Hz-30KHz, +/-3dB

.................................................................................................. 780k ohms

................................................................................................. 10k ohms

.......................................................................................................... +/-470 ohms

.......................................................................................................... +2dBv/980mV

............................................................................................................................................. 0.02%

............................................................................................................................................. -108dB

............................................................................................................................................ 4uV

............................................................................................................................. -101dBu

.................................................................................................. 2 Unbalanced 1/4" Phone Jack

..................................................................................................... 2 Balanced XLR Connector

............................................................................................... 2 Unbalanced 1/4" Phone Jack

....................................................... 9 Volt Battery or Phantom Power 24-48 VDC

.............................................................................................................................. 10mA

........................................................................................................................ 0.98 lbs. (.36 kg)

....................................................................................... 5" x 3.7" x 2.2" (127 x 94 x 51mm)

Connected to Instrument
The ADI-2 can be used to connect the unbalanced output of an instrument or line level
device (eg. guitar, bass, synthesizer, effects module, another mixer) to the balanced
input of a mixer or amplifier. Set the GUITAR/SPEAKER (3) switch to GUITAR for this
application. If you desire to send the original unbalanced signal on to a mixer or
amplifier, use the 1/4" unbalanced output (5).  The 1/4" output (5) is paralleled with
the input, therefore, when using the 1/4" output (5), the input device and output device
volume controls may need to be adjusted to acquire the desired level.

Connected to Amplifier
The ADI-2 can be used to connect an amplifier’s speaker output, or a speaker’s “daisy
chain” output, to the balanced input of a mixer. Set the GUITAR/SPEAKER (3) switch to
SPEAKER for this application.  If your speaker has only one connector, the ADI-2 can
be inserted between the amplifier and speaker using the 1/4" input (4) and 1/4" LINK
OUTPUT (5)

 jacks.

ADI2_manual

2/9/05, 10:55 AM

2