Cobra Electronics FRS 225 ユーザーズマニュアル
2
The TX/RX indicator
will be displayed.
will be displayed.
Operation
7
Note
While the TALK button is
depressed you cannot
receive incoming calls.
depressed you cannot
receive incoming calls.
Note
Both units must be ON and
tuned to the same channel.
tuned to the same channel.
Your incoming “Call” signal
volume is dependent on the
unit volume setting.
volume is dependent on the
unit volume setting.
Roger Beep
Confirmation
Tone
Confirmation
Tone
Listening For
Another Party
Another Party
Operation
6
Calling Another Party
To alert another party that you wish to
communicate:
communicate:
Talking To Another Party
Push and release
CALL button. The unit
you are calling will hear a two second ringing
tone.
tone.
Roger Beep Confirmation Tone
Calling
Another
Party
Another
Party
Note
While the TALK button is
depressed you cannot
receive incoming calls.
depressed you cannot
receive incoming calls.
Talking To
Another Party
Another Party
call
call
1
3
4
call
BATT LOW
lock
mode
1
BATT LOW
call
Release
TALK
button and listen for
response.
response.
Hold mic about 2 inches
from mouth. Speak in a
normal voice.
from mouth. Speak in a
normal voice.
Push and hold
TALK button.
TALK button.
Listening For Another Party
When finished talking:
Release
TALK button to receive incoming
transmissions.
Your microTALK® is always in listening mode
when the TALK button is not pressed.
when the TALK button is not pressed.
Adjust volume by turning the On/Off Volume
Switch
Switch
1
Your listener will hear an
audible tone when you
release the TALK button.
audible tone when you
release the TALK button.
This alerts the other party
that you are finished talking
and it’s OK for them to begin
talking.
that you are finished talking
and it’s OK for them to begin
talking.
call
BATT LOW
lock
mode
2