AT&T R1V2 ユーザーズマニュアル
Administering Data Line and STARLAN CP Ports
Procedures in this section apply to:
■
A data terminal connected to a Data Line Card (DLC) via an ADU, but not to a data
terminal connected via a modem
■
A STARLAN Interface Circuit Pack (STARLAN CP) in DLC-compatibility mode.
This section describes how to:
Using the Port and PDC Menus:
Class-of-service options for data terminals can be
administered from either the PDC menu (Main Menu item 2) or from the Port menu (Main
Menu item 1). This makes it convenient for you to administer a station based on the
information you have. If you know the station DDC, use Menu 2; if you know the station
location (CSSPP) but not the DDC, use Menu 1.
Menu item 1). This makes it convenient for you to administer a station based on the
information you have. If you know the station DDC, use Menu 2; if you know the station
location (CSSPP) but not the DDC, use Menu 1.
Adding a Data Station
You cannot add a data station to a port where a station already exists. You must first remove
the existing station, then add the new station. See the procedure entitled Removing a Data
the existing station, then add the new station. See the procedure entitled Removing a Data
To add a data terminal
1
At the Main Menu prompt, enter
1.
[AG]
2
At
Port = ,
enter the carrier/slot/port (CSSPP) for the data
terminal you’re adding. For example, enter
10608
if you
want to add a station to port eight, slot six, in carrier one.
If the port is available, you see the following message:
Port not translated
3
At
Action = ,
enter
1.
(continued)
Administering Data Line and STARLAN CP Ports 8-1