VTech CS6229 ユーザーズマニュアル

3

Each newly purchased handset (

CS6209) must be registered to the 

telephone base (

CS6219, CS6228 or CS6229) before use. When first 

purchased, each expansion handset shows 

NOT REGISTERED.

To make registration easier, read all of the instructions on this page 

before you begin. If the handset screen does not show 

LOW BATTERY or 

HANDSET X, you will need to charge the handset for at least five minutes 

before registering to the telephone base.
To register a handset:

Place the unregistered handset in the telephone base or charger. If 

FIND HS 4 SEC ON BASE does not appear on the handset screen after 

a few seconds, remove the handset and place it in the telephone base or 

charger again.
On the telephone base, press and hold    

FIND HANDSET for about four 

seconds (until the red 

IN USE light on the 

telephone base turns on) and then release the 

button. The handset shows 

PLEASE WAIT... 

and it takes about 10 seconds to complete the 

registration. The handset shows 

X REGISTERED (X represents the handset 

number assigned) and you hear a beep when 

the registration completes.

When the registration is complete, the newly 

registered handset is assigned the next available 

handset registration number. For instance, if you 

already have 

HANDSET 1 and HANDSET 2, the 

next registered handset is 

HANDSET 3.

1.

2.

If the registration fails, the handset shows 

. To reset the 

handset, remove the handset from the telephone base or charger and place it 

back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
Only one handset can be registered at a time.