Toshiba EO1-33057D ユーザーズマニュアル

7. SUPPLY SPECIFICATIONS

ENGLISH VERSION EO1-33057

7.1 Media

E7- 2

7.1.2 Detection Area of the Transmissive Sensor

The detection range of the Transmissive Sensor of the movable sensor is 70 mm from the media edge.
The Transmissive Sensor of the fixed sensor is positioned at 10 mm from the centre of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.

<Label>

<Tag paper with square holes>

NOTES:
1.  To ensure print quality and print head life use only TOSHIBA TEC specified media.
2.  The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).
3.  Backing paper must be wider than a label; the distance between the edge of the backing paper and that of a label

should be at least 1.5 mm.

4. When using a label stock in cut mode, be sure to cut the gaps. Cutting labels will cause the glue to stick to the

cutter, which may affect the cutter performance and shorten the cutter life.

5. To tear off printed media in batch issue easier, set the Auto Forward Wait function (FORWARD WAIT

parameter) to ON in the system mode. When this function is effective, the printer stops feeding the printed media
past the strip shaft. In case of a label stock, however, if a next label is issued without tearing off the printed label,
the label may peel while it is fed backward, causing a printer failure.

Sensor position

Area to be detected.

Centre of media

Print side

Min. 12 mm

Label
Gap
Label

Min. 2.5 mm

70mm

Movable Sensor

Media feed direction