Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. GE
  4. DSR-1000eZ
  5. ユーザーズマニュアル

GE DSR-1000eZ ユーザーズマニュアル

ダウンロード
ページ / 64
Calibur DSR-1000eZ 
1-4 
0150-0238A 
Video Out: Composite video output with BNC style connector. 
Ethernet Port (Ethernet models only) 
Wire Type:  CAT5 
Connector Type:  RJ-45 
Max Cable Length: 100 feet / 30.5 meters 
Minimum Cable Length:  6 feet / 1.8 meters 
Hub Wiring Configuration:  Straight Through 
PC Wiring Configuration:  Cross Over 
The cable connection configuration depends on your 
network configuration: 
• 
For a DSR-1000eZ that connects directly to a 
Hub, use a Straight Through connection. 
• 
For a DSR-1000eZ that connects directly to a 
PC, use a Cross Over connection. 
Consult with your MIS personnel for the specific type 
of configuration.  See section 5.5 Advanced Menu 
→
 
Communications for information about configuring 
the ethernet settings in the menu system. 
 
RJ-45 Pin Configuration for Ethernet Port 
Pin 
Use 
 
Pin 
Use 
 
1 
TX+ 
 
5 
Not Connected 
 
2 
TX- 
 
6 
RX- 
 
3 
RX+ 
 
7 
Not Connected 
 
4 
Not Connected 
 
8 
Not Connected 
 
 
 
 
 
 
 
8
2 3 4 5 6 7
1
 
RJ-45 Connector on 
Back Panel 
 
Power Connector 
Power Supply Input 
 
Power Supply Output 
Voltage:  120 to 240 Volt AC 
Tolerance:  ±10% 
Frequency:  50 to 60 Hz 
 
Voltage:  12 Volt DC 
Power:  35 Watt 
Connector:  2.1mm barrel, Center 
Positive 
SCSI Port 
Connector:  50 Pin, High Density SCSI-2. 
Gender (on unit):  Female 
Compatible devices:  DAT, AIT, CD-R, CD-RW 
Autoloader Support?:  No 
SCSI ID:  0 
The unit is equipped with a SCSI port for 
connecting external archive devices.  The unit only 
supports a single SCSI device.  The SCSI ID must 
be set to 0. 
The SCSI bus must be terminated, otherwise the 
system will not operate properly. 
Additional menu setup may be necessary to 
configure archive device.  See section 4.6
 
Main 
Menu 
→
 Archive Setup.