JVC DR-MH20S ユーザーズマニュアル

ページ / 84
Masterpage:Right+
EN
 
43
Filename [DR-MH30US_06HDD Operation.fm]
BASIC OPERATIONS ON HDD DECK
Page 43
Thursday, 8 July 2004  15:30
This unit records pictures onto the hard disc, instead of video 
tapes, then plays back the pictures recorded on the disc. This 
makes it possible to achieve high-speed writing and read-out that 
has not been possible with conventional VCRs, enabling recording 
and playback simultaneously.
It is called “Live Memory Playback” to start playback of the program 
being recorded, with a time-lag between a recording point and a 
playback point, as shown in the figure below.
Not only can this unit play back a program previously recorded 
while recording or timer recording another program, but the unit 
also allows you to play back from the beginning of a program while 
continuing to record the same program.
Temporary recording for Live Memory
This unit automatically records the channel being received, within 
the specified range of time, to the reserved space on the hard disc. 
The time range can be set for 30 minutes, 1 hour, and 3 hours. 
(
NOTE:
Previous temporary recordings will be overwritten since the unit is 
always recording the channel being received. Thus, it is not possible to 
play back TV programs recorded beyond the specified range of time 
since they are already overwritten. To avoid this in order to save titles, 
perform normal recording (
pg. 40), timer recording (
or Live Memory Recording (
Recording/playback Status Display
NOTES:
● Live Memory Playback cannot be performed for approximately 30 
seconds after recording has started.
● Although high-speed search up to approximately 30 seconds before 
the current recording point is possible during Live Memory Playback, 
once the current recording point is reached, the unit resumes normal 
playback and maintains a delay of approximately 30 seconds so that 
recording and playback can continue.
● When using Live Memory Playback during timer recording, playback 
continues even after the end of the recording.
● When using Live Memory Playback during timer recording, playback 
is automatically stopped just before recording starts, and then 
recording starts when the time arrives for the next timer-program.
● It is impossible to perform ITR even if you press 7 during Live 
Memory Playback. (
Press 8 to display the program being recorded, then perform ITR 
settings.
● Playback may be paused for a moment during Live Memory 
Playback, which does not interfere with recording.
● Live Memory Playback cannot be performed while recording the 
source from DV input. (
● When LIVE CHECK is pressed to display the picture currently being 
recorded, the picture size may not be correct.
● Press 7 or LIVE to stop Live Memory Playback.
● Live Memory Playback cannot be performed, even if the “LIVE 
MEMORY” is set to other than OFF in “HDD SET UP”, because 
temporary recording on HDD stops during recording on DVD.
Live Memory Playback
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/DBS/DVD switch to DVD.
● Press HDD so that the HDD lamp lights up on the unit.
About limitation on temporary recording
The temporary recording for Live Memory is cancelled in the 
following cases, and will start all over again when it is to resume.
● When the power is turned off
● When the system is powered again after a power failure was 
occurred
● When normal recording, timer recording, Live Memory Recording, 
or Automatic Satellite Program Recording (
pg. 50) is performed
● When the “LIVE MEMORY” setting is changed (
● When tuner channel setting is performed (
● When dubbing is performed by pressing DUBBING (
● When “DV” is selected by pressing CH +/– (
Playback
(High-speed read-out)
Recording
(High-speed writing)
High-speed spin
Image figure of the hard disc
Current recording position
(Recording point)
Recording start point
Current playback point
(Live Memory Playback)
0
30 min.
1 hour
Playback 
continues
Recording 
continues
Currently elapsed recording time
NAVIGATION
8
ON SCREEN
CABLE/DBS
DVD
TV
LIVE
Live Memory Playback status can be checked by 
pressing ON SCREEN to display the bar meter on 
the superimpose display. The current status is 
superimposed on the TV screen. (
Press NAVIGATION to display Library Database 
Navigation menu, then choose a program to play 
back. (
DR-MH30US_00.book  Page 43  Thursday, July 8, 2004  3:32 PM