JVC DR-MH20S ユーザーズマニュアル
Filename [DR-MH30US_09Editing.fm]
Masterpage:Left0
66
EN
Page 66
Thursday, 8 July 2004 15:30
SYSTEM CONNECTIONS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
Digital Decoder or an amplifier with built-in DTS.
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
optional coaxial cable.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
DIGITAL/PCM”. (
● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
● Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
Or An Amplifier With Built-in DTS
1
L-2
Note for connection:
Remove the protection cap from the optical
cable.
Remove the protection cap from the optical
cable.
Optical cable
(not provided)
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not provided)
(not provided)
DIGITAL OUT (COAXIAL)
DIGITAL OUT (OPTICAL)
DR-MH30US_00.book Page 66 Thursday, July 8, 2004 3:32 PM