Panasonic VDR-D160GN ユーザーズマニュアル

ページ / 116
Re
cording
Recording motion pictures
39
LSQT1184
≥ The maximum number of scenes on a disc 
(per side): 999 (Even if there is remaining capacity 
for recording (on a disc), you may not be able to 
record 999 scenes.)
≥ While “WRITING THE INFORMATION ON THE 
DISC.” is displayed, do not disconnect the AC cable 
or remove the battery as doing so may make the 
disc unusable.
≥ Sound is recorded in Dolby Digital from the internal 
stereo microphone on the front of the unit. Take 
care not to block this microphone.
≥ Each time the unit enters the recording pause 
mode, the counter display will be reset to 
“0h00m00s”.
Remaining time left for recording
(When the remaining time is less than 1 minute, [R 0h00m] 
flashes red.)
Recording mode
Recording time elapsed
≥ While motion picture recording is in progress, do not 
disconnect the battery or AC adaptor. If you do, a 
repair disc message may be displayed when the 
power is turned back on. (l 99, About recovery)
Screen indications in the disc recording mode
R 0h02m
R 0h02m
R 0h02m
0h00m10s
0h00m10s
0h00m10s
SP
A
B
C
Immediately after recording finishes the ACCESS/PC lamp lights. While it lights, the disc is 
rotating and disc information is being recorded. If you run while holding the unit or swing it, the 
recorded images may be distorted so do not strongly shake or cause impact to it.
LSQT1184(ENG).book  39 ページ  2007年2月5日 月曜日 午後1時29分