Pelco DX3000 ユーザーズマニュアル

The DX3000 Series DVR has an unmarked lock
button to restrict unauthorized use of the re-
corder. The lock button will work only as long as
no one discovers its function. Since you may
need to make the manual accessible to others,
the lock button’s location and operation are 

documented in the manual – this is the only place
it is shown.

If you want to keep this page in the manual, just
staple it inside the cover.

The lock  button is located on the front panel
below the PRE ALARM REC light.

When the LOCK button is pressed (with a ball-
point pen, for example), the front panel controls
are disabled except for the CAMERA, SPLIT/
SEQUENCE, and ZOOM buttons. The LOCK
indicator light illuminates when the unit is in the
Lock mode. Press the LOCK button again to exit
the Lock mode.

The simple lock function does not work if a pass-
word has been entered into the recorder (refer
to Password Lock ).

Pressing the LOCK button on the front of the
unit lets you record a password. Once the pass-
word has been entered and the unit has been
locked, 

the front panel controls are disabled

except for the CAMERA, SPLIT/SEQUENCE,
and ZOOM buttons.

1. Press the LOCK button for five seconds.

The Password Setting menu appears.

2. Enter a four-digit password. The password

may consist of the numbers 0-9. 1-9 are as-
signed to the camera buttons on the front of
the unit. 0 is assigned to the ZOOM key.

3. Turn the SHUTTLE ring to the right to enter

the password.

4. Re-enter the password, and then turn the

SHUTTLE ring to the right. The password is
now set, and the normal operating screen
appears.

If the wrong password is entered, “PASS-
WORD ERROR” appears on the screen, and
the password is cleared. Turn the SHUTTLE
ring to the left to exit the menu. Press the
LOCK button to turn off the indicator light.
Return to step 1.

3500 Pelco Way

Clovis, CA 93612 USA

North America and Canada

Tel 800/289-9100

FAX 800/289-9150

DataFAX 800/289-9108

International

Tel +1 559/292-1981

FAX +1 559/348-1120

DataFAX +1 559/292-0435

PelcoEurope BV

Tel +31 40/251-9870

FAX +31 40/251-9835

®

1. Turn the Password Lock feature OFF (refer to

Turning Password Lock On and Off ).

2. Press the LOCK button for five seconds.

The Password Lock menu appears.

3. Enter the current password, and then turn the

SHUTTLE ring to the right. The Password
Setting menu appears.

4. Using the same procedure for setting the

original password, enter and set the new
password.

If you are asked to enter a password and you
enter the wrong one, press the WARNING RE-
SET button to clear the incorrect password.

 

To  disable the Password Lock feature,

press the LOCK button, enter the password, and
turn the SHUTTLE ring to the right.

 To return to locked status, press the LOCK

button again.

If you no longer need a password, or if you for-
get your password, the current password can be
erased.

1. Press and hold the INFO and SET UP but-

tons on the front of the recorder. Press the
RESET button on the back of the unit, and
then release the INFO and SET UP buttons.
The unit begins a self-test.

2. When the self-test is complete, press the

RESET button again. The unit turns itself off.

3. Turn on the power.

4. Reset the time and date.