Pelco DX3016-060 ユーザーズマニュアル

Pelco Manual C681M-D (2/02)

67

5.

Press the PLAY or PAUSE button to play back the searched image.

6.

Press the STOP button to stop playback and exit the search function.

Data recorded on an external copying or archiving device can be played back on a per-
sonal computer or laptop computer.

1.

Make sure the PC or laptop computer has the DX3016RX Remote Viewing Software
installed on it. The software was supplied with your DX3000 Series recorder or can be
downloaded from Pelco’s website at Pelco.com.

2.

Connect the external copying or recording device to the PC or laptop computer.

The recorder can back up data which is recorded on the hard disk drive. You can back up
data previously recorded data at the same time the DVR is recording new data (refer to the
section on 

Simultaneous Recording and Backup

).

There are two ways to make copies:

Using the ARCHIVE button

Using the COPY button

If you use the ARCHIVE button, the peripheral recording device must be

assigned to SCSI ID number 4.

Press the ARCHIVE button. The button starts blinking. While the light is blinking, the
archiving process is being set up. This may take several minutes. When the light remains
on, the backup is in progress.

When the ARCHIVE button is pressed, the recorder makes backups after the point indi-
cated by the Archive Pointer. If the Archive Overwrite setting is OFF, the backup process
will not overwrite data already recorded on the storage medium. If ON, data previously re-
corded on the storage medium will be overwritten and erased. Refer to 

Archive, Overwrite

in the 

Programming

 section.

The position of the Archive Pointer will not be erased when the unit’s main power switch is
turned off. To reset the position of the pointer, refer to 

Archive Pointer Reset

 in the 

Pro-

gramming

 section.

Press the ARCHIVE button. The button blinks while the archiving process is halted. If the
Auto Eject setting is ON, the medium is automatically ejected at the end of the process.
The Archive Pointer is repositioned to where operation was stopped, and the next backup
recording will begin at this point.

Timer backup is a method for using the timer to perform archive backup. The timer can be
used to archive data in the main hard disk drive that has not yet been backed up. The unit
can archive data even if it is currently in the process of timer recording.

Refer to 

Timer Recording

 in the 

Programming

 section to program the recorder. In the Mode

setting, select ARC.

The recorder makes backups on the archive device after the point indicated by the Archive
Pointer if the ARCHIVE OVERWRITE setting is OFF. If ON, data previously recorded on the
storage medium will be overwritten and erased. Refer to 

Archive, Overwrite

 in the 

Program-

ming

 section.