Precor C842i ユーザーズマニュアル

The cycle can display user prompts, text, and user entries in six 
different languages. When the cycle is shipped from the factory, it is 
set to display English. To change this setting, perform the following 
steps:

1. At the Precor banner, press the following C846i number keys in 

sequence and without pause: 

RESET, 5, 6, 5, 1, 5, 6, 5

 

Numbers appear on the display as you press the associated key.

Note: The C842i does not have a number keypad, so each key is 
associated with a number. Refer to Diagram 4. To enter club 
programming mode and change the language, press the 
following sequence: RESET, SELECT, RESISTANCE 

▼, 

SELECT, COURSE CHANGE 

▲, SELECT, RESISTANCE ▼, 

SELECT. 

At the SELECT LANGUAGE prompt, use the arrow keys to 
choose between ENGLISH, DEUTSCH, ESPANOL, 
FRANCAIS, NEDERLANDS, RUCCKIJJ (C846i only), and 
PORTUGUES. 

Note: Programming prompts are not affected by language 
selection. The prompts in this section continue to appear in 
English.

2. When you are ready, press SELECT (C842i) or ENTER (C846i) 

to move to the next program or press RESET to return to the 
Precor banner.

The cycle can display measurements in either METRIC or U.S. 
STANDARD. The default factory setting is set to display U.S. 
STANDARD. To change this setting, perform the following steps:

3. At the SELECT UNITS prompt, use an arrow key to select a unit 

of measure (U.S. STANDARD or METRIC).

4. When you are ready, press SELECT (C842i) or ENTER (C846i) 

to move to the next program or press RESET to return to the 
Precor banner.