Vision Fitness R2100 ユーザーズマニュアル

• Slide the mast cover onto the 
console mast.

• With the included wire tie, pull the
console cable, or sensor wire, and
heart rate wires, through the console
mast. Place the console mast into the
console mast mounting bracket.
Secure the mast to the bracket with
five screws (M8x15L) and four lock
washers (M8) and tighten with the
5mm T-shaped wrench. NOTE:  The
screw facing the seat does not use a
lock washer. Tighten this screw until
snug. Slide the console mast cover
down over the screw heads.

• R2000 ONLY: Turn the tension knob
to level 16. Direct the cable on the
tension knob through the tension knob
bracket. Attach the cable to the 
tension cable located in the console
mast. Secure the tension knob to the
console mast with the washer (M5)
and screw (M5x65L). Tighten with the
screwdriver.

• Remove the four screws from the
back of the console. Plug the wire 
harness and heart rate wires into the
console. Mount the console onto the
console mast with the four screws.

• R2000 ONLY: Insert the two AA bat-
teries into the console.

• Remove the two M5x15L Screws
from the water bottle cage holes on
the console mast.

•  R2000 ONLY: Secure the water 
bottle bracket to the console mast with
the 4mm L-shaped wrench and two
cap screws (M5x35L). Attach the
water bottle cage to the bracket with
two screws (M5x15L) using the 
screwdriver. Insert the water bottle into
the cage.

•  R2100 ONLY: Attach the water 
bottle cage to the console mast with
two screws (M5x15L) using the 
screwdriver. Insert the water bottle into
the cage.