Jonsered CS 2135T ユーザーズマニュアル
2
–
English
KEY
T
O SYMBOLS
Symbols on the mac
hine:
W
ARNING! Chain saws can be
dangerous! Careless or improper use can
result in serious or fatal injury to the
operator or others.
result in serious or fatal injury to the
operator or others.
Please read the operator’s manual
carefully and make sure you understand
the instructions before using the machine.
carefully and make sure you understand
the instructions before using the machine.
Always wear:
•
Approved protective helmet
•
Approved hearing protection
•
Protective goggles or a visor
Both of the operator
′
s hands must be used to
operate the chain saw.
Ne
ver operate a chain saw holding it with one
hand only.
Ne
ver let the guide bar tip come in contact
with any object.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
Other symbols/decals on the mac
hine refer to special
certification requirements for certain markets.
Symbols in the operator’
s manual:
Switch off the engine b
y moving the stop
switch to the STOP position before carrying
out any checks or maintenance.
out any checks or maintenance.
W
orking position
Chok
e
Alw
ays wear approved protective gloves.
Regular cleaning is required.
Visual chec
k.
Protectiv
e goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil fl
ow.
The chain br
ake must be engaged when the
chain saw is started.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
You will find the following labels on your chain saw:
EP
A II
The Emissions Compliance P
eriod referred to on the
Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.
devices and system may be performed by any nonroad
engine repair establishment or individual.