GSI Outdoors PNEG-1521 ユーザーズマニュアル

10

PNEG-1521     Commercial Direct Gear Drive Bin Sweep Auger

Check the components shown below to insure that the safety decals are in place and in good condition. If
a decal cannot be easily read for any reason or has been painted over, replace it immediately. Contact
your dealer or the manufacturer to order a replacement decal free of charge.

DC-1266

Danger - Bin W ell

7-1/2" x 2-1/2"

DC-1384

Danger - Keep Out Of Bin

6-1/4" x 1-3/4"

DC-1866

Important - Power Sweep Information (? 42' Bin)

7-3/8" x 2-3/4"

DC-1834

Important - Power Sweep Information (36' Bin)

7-3/8" x 2-3/4"

DC-1395

Danger - Rotating Flight

4-1/4" x 6-1/4"

IMPORTANT:  BEFORE FILLING BIN CLOSE CENTER WELL 
AND INTERMEDIATE WELL GATES.  POSITION SWEEP 
AUGER OVER INTERMEDIATE WELLS.

 

1. BE SURE POWER SWEEP CLUTCH CONTROL IS 

DISENGAGED AND TIGHTEN SET SCREW. 

2. START UNLOADING AUGER. OPEN CENTER WELL GATE. 
3. WHEN GRAIN STOPS FLOWING FROM CENTER WELL 

GATE, OPEN INSIDE INTERMEDIATE WELLS BEFORE 
OPENING OUTSIDE INTERMEDIATE WELLS. 

4. WHEN GRAIN STOPS FLOWING FROM OUTSIDE 

INTERMEDIATE WELLS, STOP AUGER. TO ENGAGE 
POWER SWEEP, ROTATE UNLOADING AUGER SLOWLY 
UNTIL CLUTCH ENGAGES AND TIGHTEN SET SCREW. 
START AUGER.