DISH Network VIP622 ユーザーズマニュアル
Remote Controls
59
Improving Receiver Control
Checking the Remote Control Address
You can see what address is programmed into the remote control by completing the
following instructions.
following instructions.
1
Press and hold the SAT mode button for three seconds, until all of the mode buttons light
up, and then let go of the SAT button.
up, and then let go of the SAT button.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (three flashes means address 3).
address number (three flashes means address 3).
Confirming Remote Control Operation
Complete the following from the nearby TV to make sure the remote operates the
receiver:
receiver:
1
Make sure the remote has fresh batteries and is in SAT mode.
2
Press SYSTEM INFO on the receiver front panel to display the System Info screen on the
nearby TV.
nearby TV.
3
Press RECORD on the remote control:
•
Remote Control 1 - The Primary Remote Address in the System Info screen changes
to match the address preset in your remote control.
to match the address preset in your remote control.
•
Remote Control 2 - The Secondary Remote Address in the System Info screen
changes to match the address preset in your remote control.
changes to match the address preset in your remote control.
4
Press POWER on the remote controls to turn on/off receiver.
222.book Page 59 Tuesday, July 25, 2006 1:30 PM